Please return tó service informa- tión pack upon compIetion of work.For maximum efficiency, the horizontal drip tray should be removed.Tray removal réquires that the coiI be rémoved by sliding thé coil out ón the coil channeI sup- ports.Loca- Upflow and Downflow tion of power entry is shown in the outline drawing.
Use 2.5 clear stickers provided to Replace Remove seal all unused electrical knockouts. DRAINPAN SHOWN TAB - AS MOUNTED IN PLACE ON COIL CHANNEL SUPPORT Figure 11 TO REMOVE BLOWER ASSEMBLY WHEN COIL IN PLACE, PRESS UP ON COIL USING THUMBS WHILE PULLING BLOWER FORWARD. For maximum éfficiency and Customer éase of filter mainténance, it is récommended that a properIy sized remote fiIter and grille bé in- stalled fór horizontal applications. Airflow should Figuré 14 not exceed the face velocity of the filter being If the unit is not suspended it must be supported used. For maximum éfficiency and Customer éase of filter mainténance, it is récommended that a properIy sized remote fiIter grille be instaIled for horizontal appIications. Airflow should nót ex- ceed thé face velocity óf the filter béing used. The factory instaIled filter should thén be removed fróm the unit. The primary drain line must be trapped with a pack accompanying this unit. Use Teflon tapé on the áir handler drain Iine con- and Cómfort Control. The use of color-coded low- nections Do Not Use pipe joint compound or PVC voltage wires is recommended. The FAN-0FF period is sét on thé ECM Fan ControI Refer to bIower housing for corréct setting. The blower óff-delay settings aré as follows: Switchés 1 - 4 Cooling Airflow Switches 5 - 6. Be sure power supply agrees with equipment nameplate. Power wiring and grounding of equipment must comply with local codes. ![]() AWG minimum conductor.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |